Power Supply: 1-2S LiPo/LiPo HV (3.5V/8.7V)
Current: 5A Continuous Peak 7A (3 Seconds)
Support BLHeli_Suite Programmable
Factory Firmware: S_H_50_REV16_77.HEX

Default Protocol: DSHOT300

Power Input: XT30

Motor

Item Name: GL1202 8700KV

Stator Specifications: D12 * H4 0.2mm

Configu-ration: 9N12P

Stator Diamter: 12mm

Stator Length: 2mm

Shaft Diameter: Φ1.5mm

Winding Specifications: 180℃ Class Multiple oxygen-free copper

Weight(g): 3.4g

No.of Cells(Lipo): 2S-3S

Frsky NON- EU XM+

Receiver Version

SBUS Receiver

Frsky D8/D16 Switchable

Compatible Non EU Transmitter both D8 and D16 mode

Channels: 8CH / 16CH

Failsafe Support

No ground interference ( Transmitter and receiver 1 m from the ground): 300m

Operating Voltage Range: 3.7~10V
Operating Current: 30mA @5V
Operating Range: Full Range
With RSSI Output on Board: Analog 0~3.3V
Firmware upgrade-able, can be upgrade to EU-LBT with RSSI

Compatible Flysky Receiver Version

IBUS Receiver

Protocol: AFHDS-2A

Channels: 14CH (AFHDS-2A)

No ground interference ( Transmitter and receiver 1 m from the ground): 300m

Failsafe Support

Compatible DSMX Receiver Version

Serial Bus Receiver

Protocol: DSM2/DSMX Compatible

Channels:6-9CH (Depend on your radio)

No ground interference ( Transmitter and receiver 1 m from the ground): 300m

TBS NANO

Receiver Version

CRSF Protocol , Official TBS transmitter compatible

Protocol: CRSF

Channels: 8CH

Failsafe Support

Support receiver hardware rssi function

No ground interference ( Transmitter and receiver 1 m from the ground): 500m

PNP Receiver Version

Support any bus and other protocols, users can install by themselves

5.8G VTX

Power Switching: Third Gear(25MW , 100MW , 200MW)

Frequency: 40CH
Input Voltage: 3.3V 5.5V
Current Consumption: 300mA (Type)
Frequency: 5.8GHz 5bands 40 channels
With Raceband

Smartaudio ready(Frsky EU-LBT and DSMX version not compatible)
Weight: 2.0g

Camera

GL950PRO: 1/4 COMS Sensor

Horizontal: 800TVL 800x600

TV System: Ntsc 4:3 non-changeable

Power Input: DC 5-12V

FOV: F1.2

Colorful: 0.1Lux(F1.2,50IRE,AGC ON)

Black and white: 0.01Lux(F1.2,50IRE,AGC ON) Signal to Noise Ratio > 50dB Dynamic Range >60dB

Lens: m7

White Balance: Auto white balance

Image: Color

BLC: Stand by

Video Format: NTSC

Weight: 1.5g

Propeller

Gemfan 2023-3 Toothpick Props

Material: PC

Weight: 0.88g

Pitch: 2.3 Inch

Props Dia: 52.17mm

Center Thickness: 5mm

Center Hole Dia: 1.5mm 3 holes

Battery Recommended

Species: lipo, lipoHV

Capacity: 450-550mAh
Voltage: 7.8-11.1
Continuous Discharge Rate: 60C
Instantaneous Discharge Rate: 80C
Connector: XT30

Features:

1. Use SH-50A flight controller to support 2-3s lithium battery power supply. The integrated Betaflight OSD function keeps track of the signal of the flight voltage receiver and can observe the status in real time during flight.

2. VTX comes with Smartaudio function, you can adjust the flight control parameters through the OSD, adjust the flight control PID, and adjust the VTX frequency point parameters Completely assembled and debugged, you can fly with the remote control.

3. A more compact design is adopted for the first time, with a wheelbase of 78mm. However, passing long-term flight tests will not affect flight efficiency at all. Indoor flight has better maneuverability and playability.The FPV end adopts GL950 camera, the image quality is clear. The complex environment of flying indoors has better observation and controllability.

4. The 3s power supply and the 2-inch three-blade propeller have been tested and matched for a long time, and have obtained good operability and durability. It is recommended to use 3s 450mah battery, if you need longer space, you can add 3s550mah battery. Through continuous improvement, the problem of low efficiency of the 2-inch air duct machine was finally solved. Indoor small cross aerial photography becomes a reality. In order to better protect the outer ring,EVA sponge material is used to improve safety and reduce wind resistance. Through optimization, the performance is very good.

5. The flight controller supports Betaflight adjustment, a variety of flight modes, carefully adjusted by the original factory, suitable for novice flight practice, stable style.

6. Independent use of multiple versions of the receiver, electronic control is more stable. The flight control adopts the newer version of Betaflight 4.2, and the ESC adopts the 16.77 version. Both the two-way DSHOT mode and the gyroscope RPM filter are turned on to make the flight control more stable.

7. The weight of the whole machine is controlled at 72g, which solves the weight problem of the traditional air duct machine and is flexible in control.

8. The original factory is equipped with two sets of 360go thumb camera mounts, which can be replaced as needed.

9. The tail RGB LED flight control can be adjusted freely.

Package Included:

1 X GEELANG LIGO78X 2.3 Inch 78mm Wheelbase FPV Racing Drone

2 X 3D Printed 360gGO Thumb Camera Bracket Red & Blue

4 X GL1202 KV8700 Motor

8 X 2023 Propeller (4CW+4CCW)

1 X 5.8G VTX5840

1 X RGB LED

1 X GL950 Camera

1 X Screwdriver Removal Tool

2 X Battery Magic Strap

1 X High-end Paper Box

1 X USB Cable

1 X 3S 450mAh LipoHV Battery

Option 1: SH50AF4 Frsky NON-EU XM+ Receiver Version

Option 2: SH50AF4 Flysky Receiver Version

Option 3: SH50AF4 DSMX Receiver Version

Option 4: SH50AF4 TBS Crossfire NANO Receiver Version

Option 5: SH50AF4 PNP NO RX Receiver Version

GEELANG LIGO78X 2.3 Inch 78mm Wheelbase Ducted CineWHOOP FPV Racing Drone PNP/BNF w/ 800TVL 800x600 GL950 Camera SH50AF4 MATEKF411 2-3S FC 4 In 1 ESC GL1202 8700KV Motor

Prices for Geelang Ligo78X 2" 4S Insta360 Go Mount PNP in stores

Deals found: 4 ()

2" Quads

Geelang Ligo78X 2" 4S Insta360 Go Mount PNP

Prices for Geelang Ligo78X 2" 4S Insta360 Go Mount PNP in stores

See also